Top Secrets to Prevent Water Heater Repairs

It can be so frustrating to discover that your water heater is not working especially when you are in the middle of showering. The case can even be worse if you are dealing with a cold winter morning. Sometimes you may turn your faucet on to just discover that you are getting cold water. You may also discover there is a problem with your water heater from the unpleasant smell. In all these cases, it is not fun to deal with the lack of hot water in your building. You will be forced to look for a professional water heater repair Alexandria va to identify the problem and provide a perfect solution.

It can even be more stressful when you discover that it is so expensive to replace or repair your water heater. It does not matter whether you are just doing a mere repair work or replacing the whole tank. Consequently, it is prudent to be aware of some of the basic steps that will keep the water heater repair costs to the minimum.

First you have to be sure that you don’t set the temperature of your water heater over 120 degrees Fahrenheit. If it is so high, it will increase your utility bill and because you are forcing your system to work hard, most of the parts will undergo a lot of wear and tear.

Check the pressure relief valve at least two times every year to make sure that it has no corrosion. If you detect this early enough, it means that there will be fewer chances of developing future problems.

Schedule a maintenance visit with a water heater repair Alexandria vaat least one time every year. You have to make sure that all these pieces and parts are working together seamlessly.

You should also check to it that there is sufficient ventilation. This is more important of you are using a gas heater. If the vents are not working properly, you home may be invaded with toxic fumes.

Take time and drain your water heater and remove and sediments at least two times every year. If you allow the sediments to build up, it can lead to a broad range of problems. Place a 5-gallon bucket below the drain valve to drain the tank. Afterwards, turn the drain valve counter clockwise to release some gallon of water in the bucket. You can then close the valve and then proceed in the usual way.

Check the pressure and temperature valve by lifting the lever up part way and allowing it to snap into place. You will hear a gurgling sound which indicates that some water was released into the drain pan. If you will not hear anything, know that time is ripe to replace the valve.

If you own a gas water heater, spare time at least one time every quarter to make sure that the pilot light is lit. You also need to remove and buildup of soot.

These tips will only help you if you choose to apply them. Therefore, don’t wait until your water heater calls for repair before you start using these tips. Begin today and you will significantly enhance the lifespan of your water heater. If you still have some questions, don’t hesitate to talk to your professional plumber today.

Leave a Reply

Your email address will not be published. Required fields are marked *